Daytona A&K / CA M249 HPA Recoil Conversion Kit

500,00520,00

Conversion Kit Voor De CA M249 / A&K M249 /Echo1 M249 / Matrix M249 series AEG

 

Wissen
Artikelnummer: 201030 Categorieën: ,

Designed for CA M249 / A&K M249 /Echo1 M249 / Matrix M249 series.

The Daytona Airsoft m249 kit is to convert your AEG M249 to an HPA powered recoil system and let you take AEG M249 box mags or M4 mags. No suffering from green gas or propane cool down.

Components Material:

Machined Steel, brass and 6061 aluminum

70 Dura synthetic rubber

Bolt Carrier Material:

Steel bolt with brass bolt tank

Range test:

https://www.youtube.com/watch?v=vDTS1PGO9tQ

Stress Test:

https://www.youtube.com/watch?v=pR3kim5GjV8

The Daytona Airsoft System kit means you can have even more recoil, more noise than a GBB system, and increased effective range like the fusion engine, without spending a fortune on GBBR mags. It requires around a 2000-4000 bb break-in period where a small number of fliers and chopping of bbs may occur. This is normal while the system is breaking in.

You are required to install an AEG barrel made of either brass or steel. Never use aluminum barrels since it will be bent by hop up set screws. You also need to prepare an HPA tank and Redline regulator with single QD disconnector wide bore airline.

During the break-in period, please keep lubing your gun with getsome 1000 lubricant. Only use quality BBs that you intend to use for gaming during break-in, never cheap out.  As soon as all your shots are consistent you can turn on the hop-up gradually (1/8 turn each time) until you reach your designated trajectory.

Low Power Modification Required(sub 320fps w/ 0.2gBB)?

Check our Low Power Airshaft above:

Downgrade naar ±1 Joule

Nee bedankt, Ja graag (+€20.00)

Beoordelingen

Er zijn nog geen beoordelingen.

Wees de eerste om “Daytona A&K / CA M249 HPA Recoil Conversion Kit” te beoordelen